Kanga XH Range Grader Blade

Made in Australia, KANGA XH Range Grader Blades are an extra heavy-duty blade with full hydraulic movement, engineered to suit tractors 75 to 130hp.

The operator can hydraulically adjust the blade to move material side to side, offset the blade to grade in hard to reach areas and tilt the blade to create a slope or for drain cutting and management.

The KANGA XH Grader Blade can also be set up with the blade reversed and the hydraulic rams on the internal side. This allows the operator to back blade, clearing scrub and debris with less chance of damaging hydraulic rams, hoses and tractor tyres.

The KANGA XH Range has undergone extensive field testing in harsh Australian conditions; creating and maintaining dirt roads, firebreaks and drains, clearing dense scrub and heavy-duty grading and scraping.

Features:

Construction

Main beam

• Single, 1,500mm long piece of square 150 x 150 x 9mm Box Section provides greater strength
• The front mounting plate is reinforced for greater structural integrity
• Adjustment mounting lugs reinforced and/or gusseted so you can reposition the blade while operating

Blade mouldboard

• Reinforced and gusseted 10mm rear blade section
• Involuted design to ensure a high volume of material clears from the blade as the operator is working
• The blade is designed to be reversed 180° for back blading (pushing backwards)
• 650mm ground clearance

All three blade adjustments pivot points are bushed and/or reinforced with external grease nipples for easy lubrication

Grading

The cutting edges are:

• 150 x 12mm with countersunk bolt holes
• Heat-treated, through-hardened, quenched and tempered alloy steel
• Hardness ratings between 450-510
• Centre-line drilled making them reversible
• Secured with high-tensile plough bolts

The main beam positions the majority of the implement weight over the cutting edge reducing blade ‘bounce’ leaving a smooth level finish

Adjustment

3-way hydraulic adjustment with external grease points

Adjustments are made using 4″ hydraulic cylinders with 1/2″ hoses and fitting

Angle adjustment

Angle adjustment controls the blade section and cutting edge on the horizontal plane. It controls the lateral movement of material

Angle adjustment range: 0° – 30° forwards and backwards

Tilt adjustment

Tilt adjustment controls the blade section and cutting edge on the vertical plane. It is used for creating a camber or slight angle to the ground surface. At the maximum, it can be used to establish and maintain a ditch or drain

Tilt adjustment range: 0° – 30° up and down

Offset adjustment

Offset adjustment controls the position of the blade section and cutting edge in relation to the middle point of the tractor. It is used to move the blade and cutting edge out to the sides left and right of centre. It’s great for those hard-to-reach places and when the tractor just cannot quite get close enough or does not want to.

Offset adjustment range: 0° – 20° left and right

3PL information

Centre mounted tower position

Two (2) front parking stands to make connecting to the tractor easier

Wide, Category 2 and 3, double clevis linkage/mounting

Delivery can be arranged Australia-wide for a fee

Finance available CLICK HERE